Home-automation RC-80BZ Instrukcja Użytkownika Pobierz pdf (Strona 14)

1

1

4

4

The thermostat supports the following command classes:

COMMAND_CLASS_THERMOSTAT_MODE

COMMAND_CLASS_THERMOSTAT_SETPOINT

COMMAND_CLASS_THERMOSTAT_FAN_MODE

COMMAND_CLASS_THERMOSTAT_FAN_STATE

COMMAND_CLASS_THERMOSTAT_OPERATING_STATE

COMMAND_CLASS_SENSOR_MULTILEVEL

COMMAND_CLASS_ASSOCIATION

COMMAND_CLASS_CONFIGURATION

COMMAND_CLASS_VERSION

COMMAND_CLASS_MANUFACTURER_SPECIFIC

COMMAND_CLASS_SWITCH_BINARY

COMMAND_CLASS_CLOCK

COMMAND_CLASS_THERMOSTAT_MODE

Upon power up, allow 10 seconds for the RC-80BZ thermostat to initialize. After 10 seconds, a controller can

set the mode, get the current mode, and get the modes supported by the thermostat.

COMMAND_CLASS_THERMOSTAT_SETPOINT

Upon power up, allow 10 seconds for the RC-80BZ thermostat to initialize. After 10 seconds, a controller can

change setpoints, get current setpoints, and request the setpoints that are supported by thermostat.

COMMAND_CLASS_SENSOR_MULTILEVEL

The RC-80BZ thermostat uses this command class to report the actual temperature.

COMMAND_CLASS_ASSOCIATION

Upon power up, allow 10 seconds for the RC-80BZ thermostat to initialize. After 10 seconds, a controller can

issue an Association Set, Remove, or Get command. The thermostat must be associated with a controller to

provide feedback.

COMMAND_CLASS_CONFIGURATION

Upon power up, allow 10 seconds for the RC-80BZ thermostat to initialize. After 10 seconds, a controller can

change individual register settings for the outdoor temperature. The Parameter Number is 67. The size of the

data is a 1 byte value. The Value is the temperature to which the register is set.

COMMAND_CLASS_THERMOSTAT_FAN_MODE

Upon power up, allow 10 seconds for the RC-80BZ thermostat to initialize. After 10 seconds, a controller can

set the fan mode, get the current fan mode, and get the fan modes supported by the thermostat.

COMMAND_CLASS_THERMOSTAT_FAN_STATE

Upon power up, allow 10 seconds for the RC-80BZ thermostat to initialize. After 10 seconds, a controller can

request the state of the fan.

1 2 ... 9 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag